rsmithsr
Registered User

why not do it the other way around?? put the case in a k&m case holder in the chuck, and hand feed the cutter. i do this in two passes(two...

the hart is a nice press but a bit over kill for seating bullets. me thinks the $100 presses will do fine for that task (or neck sizing) add fl...

just because the load is "below maximum" is no proof that the firing pin is the issue. primer issues are "normally" a load issue.

when WIND is an issue, make smaller narrower frames...less for the wind to move around. put a 2x6x( you pick the length..24/36/48) in a 6x8x(plus...

i like "DUMBER THAN A ROCK" BULLETS !!!!!!!!!!!!!

Churches vs squirrels The Presbyterian church called a meeting to decide what to do about their squirrel infestation. After much prayer...

i do not think an executive order can contravene the constitution.

tim if you are talking about their rotary tumbler, the drums sometimes GROW in length. tap them on a hard floor to shorten them and then try...

the first pic "looks like" the bbl is pointed up...not square with the cylinder.. just the pic ???

as long as real americans own firearms. taking them away will never be easy. only when all the ammo is gone. i would guess all the politicians would...

thanks, got it ordered.

will anyone list a contact phone number... when i click contact on the site i get nothing thanks

only the top 10 from each class is in the magazine. that is what i used.

thanks, i'll go look..spend some money

simply part of the problem. large over paid poor producing group. most fund raising is outside groups that take most of the money. just like the 2...

so does any make a one sided hss thread cutter / where one can get real close to an edge look at bbl threads, a full size tool will not fit, cut...

what do you call 50 lesbians and 50 senators in one room ???? x x x x x x x x x

serious question what about russian sks ??? the chinese were made on tired russian tooling, then their own.

ak/sks out performs the ar at short range,1-250 or so, then the accuracy of the ar takes over for the record an ak zero'd at 100 has a TWENTYSEVEN...

politicans, not the men nor the guns

actually 1/4 moa is not hard with the right parts..we are not talking about an m16/m4 clone, but an ar target rifle.

yeah...rib

so slab sided with big underlug, thin the top with a (not a rail, but like a rail) name eludes me as i type.

actually 4 were from california, and were shooting plastic straws which are not legal there. they had no comment on bbl maker.... or i missed, but...

i think it might be muzzle heavy!

as i had said, i needed FACTS, not opinions..the conversation was outside the br world. the numbers, all four classes. top 10 bartlein 24...

no. the pumpkin is ground offset for micro adjustment.

i have tried them in my ar's. very poor in the accuracy game. function ok, blasting ok, little other use

2000 lbs.....

years ago i thought there was a post where more experienced workers made the match, plus more inspections..