Tab Content
  • WallyDog's Avatar
    06-15-2020, 09:37 PM
    I would go down to a .261-.262 neck bushing. A load of 29.2 won’t give you pressure problems. If you start getting sticky or hard lift on the bolt...
    8 replies | 914 view(s)
  • WallyDog's Avatar
    06-15-2020, 09:31 PM
    I made a bushing at .261 and it is much better for tension. I had to re-find the jam length. Im kissing the lands now. With the extra tension I can...
    8 replies | 914 view(s)
  • WallyDog's Avatar
    06-15-2020, 02:46 PM
    Its a new 13.5 twist Kreiger. Its a .268 chamber but Im at about .265 loaded round. Didnt want to mess with tight neck tolerances. Using a .264...
    8 replies | 914 view(s)
  • WallyDog's Avatar
    06-13-2020, 06:30 AM
    WallyDog replied to a thread What caused this in Gunsmiths Corner
    That looks just like an out of center threading tool. Looks to be dragging. A HSS cutter would likely give a better finish with sulphurated oil. Some...
    18 replies | 2041 view(s)
No More Results
About WallyDog

Basic Information

Statistics


Total Posts
Total Posts
80
Posts Per Day
0.04
General Information
Last Activity
06-17-2020 08:48 AM
Join Date
05-22-2015