The rear sight (Metrolite) on my 1911 has a very small set screw.
The allen head is rounded off therefore the set screw can not be loosened.
The sight needs to be adjusted.
Kimber is sending another set screw.
The screw needs to be removed without maring the slide (bottom of the hole); because that would inhibit the fine adjustment of the sight.
What is the best approach to remove the set screw?
Even though I am getting a replacement screw, I think a larger torque screw might be better.
A mill is avaible for the operation.
The allen head is rounded off therefore the set screw can not be loosened.
The sight needs to be adjusted.
Kimber is sending another set screw.
The screw needs to be removed without maring the slide (bottom of the hole); because that would inhibit the fine adjustment of the sight.
What is the best approach to remove the set screw?
Even though I am getting a replacement screw, I think a larger torque screw might be better.
A mill is avaible for the operation.