johan teughels
Member
just a brainfart ...is the 120 dgr taper cut setting ( for the bolt) the same setting as the 30 dgr setting for the 60 dgr thread cutting ?
just a brainfart ...is the 120 dgr taper cut setting ( for the bolt) the same setting as the 30 dgr setting for the 60 dgr thread cutting ?
Simple answer, yes.
But, do not set your compound at 30 degrees. Set it at 29 degrees, so it will have a tad more clearance toward the OD of the cone, but still have the same support of the case web at the case head.