2 piece bases on 64 Anschutz ?

D

digisol

Guest
Just bought a 64SBR and want to be able to use a pair quick detatchable rings preferably with windage / elevation adjustments in the base/s.
Can anyone assist with what model two piece bases will fit onto the 64 action so I can use conventional size base ringsets with quick release function.
I see that Leupold and others have the ringsets I seek but little information as to what bases will fit on the 64 pre drilled action.
I have a near new Bushnell Elite 5-15 X 50 scope from another rifle that should do the job until something better comes along, from what I see the ringsets should be 1" high from the conventional 3/8" / 11mm grooves and it's then very likely that after the bases are fitted (if possible) I will then need a med height ringset, this might well give me the option to then use the same scope and rings on another c/f rifle with a minimum of fuss.
Anyone done this on a 54/64 action using a 2 piece std size base ?
 
anschutz bases

I have an anschutz exemplar which in a 64 action and I used leupold bases for a Remington 541s, same radius and hole spacing, then you can decide what height rings you want.
Hope I was of some help.

Howard
 
Thanks, I had looked at the Leupold range as a preferred option, only needed the hole spacing for correct choice.

I only asked as we have no gunshops within 100+ miles so it's not a simple choice to make off the net without the dimensions and physically seeing a cross section of bases to see if they fit in more areas than just the hole spacing.
 
digisol said:
Just bought a 64SBR and want to be able to use a pair quick detatchable rings preferably with windage / elevation adjustments in the base/s.
Can anyone assist with what model two piece bases will fit onto the 64 action so I can use conventional size base ringsets with quick release function.
I see that Leupold and others have the ringsets I seek but little information as to what bases will fit on the 64 pre drilled action.
I have a near new Bushnell Elite 5-15 X 50 scope from another rifle that should do the job until something better comes along, from what I see the ringsets should be 1" high from the conventional 3/8" / 11mm grooves and it's then very likely that after the bases are fitted (if possible) I will then need a med height ringset, this might well give me the option to then use the same scope and rings on another c/f rifle with a minimum of fuss.
Anyone done this on a 54/64 action using a 2 piece std size base ?
Click to expand...

I think I got mine from RWS?
 
You must log in or register to reply here.
Back
Top