Search results

check out accurate shooters forum.

I was at a .22 match over in Antelope Valley many years ago. One guy was shooting a 10/22 and his ejections were going down the front of a nicely built ladies low neckline blouse. Each and every time she would flinch and squeak. Some things a guy just can't forget.

I have spotted through a number of different scopes and have been the most impressed with Kowa.

Start with Lapua brass and a single stage press. If you don't like the run-out/concentricity try a Lee Collet Die for neck sizing and follow the instructions. You have a lot of stuff listed for brass prep. If you start with Lapua brass most of if will not be needed. Some makes of brass will...

Congratulations! Do you have any advice for us that are working toward 47 years? John

Check this out: http://www.gunwarrior.com/1131/chamber-chiller-rifle-barrel-cooler-samples/

Justin, Thanks, I have one. John

Thanks! I'll try the RCBS tool.

I am using a Wilson case trimmer and a Wilson case mouth 30 degree deburring tool. There seems to be a ridge left inside the case neck after deburring. Reversing the direction of the deburring tool does not remove the ridge. The cutting tool may be rolling up this ridge. I have not found a...

Ronald Lee Ermey (March 24, 1944 – April 15, 2018) was an American actor and voice actor. He achieved fame when he played Gunnery Sergeant Hartman in the 1987 film Full Metal Jacket, which earned him a Golden Globe Award nomination for Best Supporting Actor. Ermey was also a United States Marine...

Thanks Justin. I'll need to dig through all my stuff for a bushing. "It's Bristol Baby"!!!! John

The caliper check is used to insure I am reading the micrometer correctly. Sometimes my eyes don't pick up all those little lines and I need to check and double check, plus I could be dyslexic or the cataract is catching up on me. Thanks for your concern.

"I think I will fire form the rest of my brass and then turn the necks", he said with a groan.

My loaded rounds measure a consistent .2715 for my barrel chambered in 6x47 Lapua. (I am using a 1" micrometer and checking it with a digital Mitutoyo caliper) The Bartlein barrel has a .273 neck diameter; therefore I have .0015 total clearance Fired case necks measure .2725. Berger 87 VLDH...

To really know what size you need, requires measurement of the scope in question. Calipers really help.

Those HS center feeds are really nice! Work slick.

WOW! We were just talking about it yesterday. Would love to have a copy. Uncut redone versions seem to be available, read the small print before ordering.

alinwa, How did you mount yours? Bolted down or clamped down to a bench? thanks

Yes, cut the female end on angle and wield to square plate.

My three legged bench uses 1 1/2" pipe set at 20 degrees and 3/4" plywood top. It is 24" wide and 48" long. Has a shooters notch 6" x 18". It is about 34" tall. I am 5'9" tall and like to sit upright when shooting. Two legs to the front one to the rear. Cut clean threads and keep them...