Welcome, Guest ( Register | Login )

Normal Browsing

Featured Classifieds in Reloading

Title Description City Price
Bryant Custom Powder Measures I just finished up a run of 6 PPC powder measures. I made two more than what I had ordered. The measures are based on the Jerry Hensler Type measure insert that Jerry used to make years ago. It throws approximately from 26 to 31.3 grains of 133 depending upon lot density of the powder. The measure uses a Mitutoyo micrometer head with .250“ spindle x .500” travel for a volume adjustment of the measure. The measure handle can be reversed if you want the handle on the opposite side by moving the 3/32” stop pin to the other side and switching everything around. These two measures are serial numbered 16 and 22. The #16 measure has been polished somewhat on a buffing wheel. The #22 finish is as turned with 320 grit finish. One turn of the micrometer head is worth close to .3 grain.  Priced at $350 plus $18 USPS priority mail shipping and Insurance.  Wheeler $368.00 USD
Ed Watson trophy match 65L, 6mm. Made on j4 .825 I have 2 unopened 1000ct boxes and 1 with over 700 left. I'm not counting them. Watson 65gr, 6mm made on J4 .825 jackets. These are excellant bullets. Made on Rorschach dies. 540.00 shipped. or best offer. We make our own bullets and will never use these.  evergreen $540.00 USD
Benchrite Case Lathe Our Case Lathe makes neck turning brass an easy, pleasant job instead of a necessary project to be dreaded and put off. This power turning system is the result of many years of using and experimenting with neck turning systems to find the best balance of speed, convenience, power, ease of use and quiet operation. The 1/20th HP gearmotor turns cases at 181 RPM with plenty of torque to prevent drag down when making large cuts. Cases are held by the updated case holder and spindle system which makes inserting, tightening and removing cases a snap. Heavy duty switch, 14 ga. power cord, professional finish and anti-vibration feet complete a tool made to perform perfectly for many years. The lathe system comes complete with large or small primer spindle and one case holder – specify cartridge. Instructions included, Made In USA. Please visit our NEW Web Site at www.benchrite.com Additional large or small spindle: $40.00 Additional case holders: $14.00 Shipping in USA: $8.95. Email: sales@benchrite.com Phone: 260-456-6809 Fort Wayne $495.00 USD