Visa, Discover, Money Order
Custom "M.A.P Master American Press" for reloading.
This press has 2 spindles that may easily be adjusted indenpendently of each other.
Your dies are help in a precision die holder which are easily adjusted with .001 graduations on the die holder. These graduations are spaced far enough apart to allow you to adjust less than .001.
Lubricate all moving parts regularly with a few drops of Kroil.
There is a .25 hole in each side of the body, this is accessable with a 1/16 allen wrench to change shell holders. Use RCBS shell holders as shell holders are not created equally.
Thumb screws on each side are the locks to hold the die holders in place after it is adjusted. Please note that very little torque on the thumb screw is needed to securely lock the die holder in place.
The press handle is held on the press with a thumb screw.
If you have trouble bumping shoulders with repetition consider annealing cases each time you load, case hardness greatly changes spring back.
$495.00 + shipping! Please call 1-800-455-0350 to order!