PDA

View Full Version : Feinwerkbau 800 barrel mounting position



new2gun
08-01-2014, 12:30 PM
I have removed the barrel from the stock and when I put it back I noticed that the if I push the barrel all the way it, the end of the barrel on the receiver side will stick out like what’s shown in this photo :

http://i11.photobucket.com/albums/a181/Canon_guy/fwb88barrelstickout.jpg

may I know if this the correct position or the step indicated in the photo should not be there ?

sgeorge
08-01-2014, 02:26 PM
Close the bolt. If it closes and seals air, the barrel is correct.

If the bolt does not close, loosen the bolts holding the barrel and then, close the bolt. Tighten the bolts again and test to see if air is sealed.

Dusty Stevens
08-03-2014, 10:48 PM
What in the world is a fienwerkbau? Sounds like a good beer