PDA

View Full Version : Bolt Release



Bill Gammon
10-29-2010, 08:15 AM
Back a few years ago you could get a after market Bolt Release that you could drill and tap into the side of the Remingtons to release the bolt. I know I had them on my earlier Remington bench rifles. If you put a Hart trigger or a Shilen you had to put one of these releases in. The old guys will know what I am talking about. I need some or at least 1 for an idea that I have. You can contact me through this forum or at bill.gammon@rogers.com
Thank You
Bill

AndyTaber
10-29-2010, 08:37 AM
These are available from Sinclair (in black or silver).

pbike
10-29-2010, 08:56 AM
This is what you are talking about Bill? This is what is available through Sinclair. Like Andy said, Black or Silver.

HovisKM
10-29-2010, 09:15 AM
Also available at Hart.

Hovis

Bill Gammon
10-29-2010, 09:19 AM
Guess who got their Sinclair Catalogue 2 days ago and has not read it yet, DUH!!!
Thanks guys and I take back the bit about you old people, EH!!!

Gunner223
10-29-2010, 10:13 AM
Bill, I use a 1/4 x 28 socket head screw. Just turn down the end a bit and run a die up to the face of the sholder. Drill and tap the action where the rear reciever sight hole is or would be.

Don

Bill Gammon
10-29-2010, 01:46 PM
What this was all about I just aquired a Savage Muzzle Loader M10 and the idea of having to undo the rear bedding screw to get the bolt out just drove me up a wall. My idea was to use a spring loaded bolt release and grind off the bedding screw. But Gunner223 you just gave me another idea, thanks.

CYanchycki
10-29-2010, 07:28 PM
One of the one's that can use SMOKELESS powder.

If so be careful Bill and be sure of your propellant.

What you bought a SAVAGE....................................... eek..................

Calvin