PDA

View Full Version : Bedding Compounds?



bored184
02-07-2008, 10:10 AM
I'm wanting to do my first bedding job, the only substance I know of is Acraglas. Are there any brands or substances out there that might be better or easier to use?

Joe
02-07-2008, 10:13 AM
Devcon Putty. Steel or Aluminum doesn't matter to me.
Very nice to work with.
Lots of time before it sets.
Thick like peanut butter and stays where you put it, does not run.

MilGunsmith
02-07-2008, 10:51 AM
Grey Marine-Tex is used by a lot of military gunsmiths. It available at Wal-Mart.

bored184
02-07-2008, 11:58 AM
I dont know if it matters but this will be done in a wood stock along with pillar bedding. I also forgot what kind of a release agent would I use? Thanks for the info so far.

crb
02-07-2008, 12:38 PM
http://www.6mmbr.com/pillarbedding.html

wnroscoe
02-07-2008, 06:19 PM
Devcon 10110 is great stuff. Gives you a perfect looking job, hard as hens teeth when it's fully cured.

333smitty
02-07-2008, 09:22 PM
I use nuetral shoe polish as a release agent.

Kelbly's beds all their benchres rifles with Devcon
Aluminum Putty. I have used it to bed 3 rifles.
It's easy to work with and is performing well.

Bill Wynne
02-07-2008, 09:43 PM
I just finished one using Devcon 10110 and the instructions on this site

http://www.6mmbr.com/pillarbedding.html

It worked great. I did a great job if I have to say so.

The thing about the Devcon 10110 is that there is almost 0 shrinkage compared to their other products.

TheConstitution
02-08-2008, 05:13 AM
I like Bisonite. Depending on whether you intend to compete with this rifle or not, you might consider a glue-in job.

bored184
02-11-2008, 01:58 PM
Thanks for all the advice