PDA

View Full Version : Looking for lead wire......



HP Drifter
12-24-2007, 02:25 PM
Wanting to find a midwest supplier for some 3/16" lead wire for bullet making if possible. Just wondering where does everyone source their bulletmaking lead. TIA.

Andy
12-24-2007, 03:40 PM
Try this lonk to R W Harts

http://www.rwhart.com/html/07cat_19.html

Andy

Gerry
12-24-2007, 04:04 PM
check your local phone book first. the shipping will break you back, unless you go by the hundred weight by truck transport.
Lead prices are way up.
If you can get some pure lead you can opt to cast and swage your cores.
You will get some waste from the bleed off and you could melt it down and cast a rough core to swage to weight.

george ulrich
12-24-2007, 07:00 PM
crown metal co. milw. wi. 414 384 6500 if you need others email me.

RL Weikart
12-24-2007, 07:38 PM
The last roll of lead wire I got was from Lester Bruno, you might check with him.

:rolleyes:

Mike Bryant
12-24-2007, 10:03 PM
The last lead wire I bought came from Mayco Industries (http://www.maycoindustries.com/extrusions.htm) in Birmingham, AL. I used to buy from Berger, but they no longer sell lead wire and Mayco was one of the suppliers that they had on their list. There were about 3 or 4 others on their list as well.

Wilbur
12-25-2007, 03:31 AM
I hear that folks are buying cores that are better than they can make.

MColeman
12-25-2007, 09:56 AM
I hear that folks are buying cores that are better than they can make.
I think Charlie Hood is supplying cores, isn't he?