Activity Stream

Some opinions about the DRO questions and comments. First of all, I've used DROPROS as my supplier and found them to be extremely thorough and...

In my experience I have found that Redding dies are a bit too long, and most I had to sand down to get the proper should bump back. You need a tool...

I turned the necks so I have .0015 clearance filled the cases with N-135 and loaded 105 VLD so it will be very stiff in the lands.. hope that will...

What color do you like? Seriously, it's up to you. Try leather, Cordura, and the new 3M material. Until you've tried them all, you won't develop a...

My son just graduated from Kutztown Uinversity. Lots of good kids there. I am positive there will be the same bloodbath they had in Wisconsin when...

I am using a le Wilson case gauge with a mitutoyo depth mic. I have adjusted the FL die so that the head space is at its minimum. I plan to...

IMO the only correct method for adjusting a FL or body die, involves using some sort of specialized tool to measure from a point on the shoulder of...

Not common, but not a problem if adjusted correctly I have ground back a FLS die to get it to push the shoulder back JRB

Guess we need a Rosetta Stone for all this "concrete talk"

What you seem to be referring to may be the "Gordy Gritters Method" of rebarreling, definitely something similar...... this method is fairly new and...

WAAAAY OFF = .015" or more in either direction. That will usually be at least .007" or so beyond either end of the run. The lube won't change my...

Generally speaking Ian these suppliers over here in the US are ethical businessmen, in for the long haul, and as such they SHOULD NOT short you'se...

Welllllll, maybe colloquially, but on the whole "walking trowel" isn't enough description. I have 6 different styles of non-motorized "walking...

Andy I'm told there is one importation of powder into Aussie each year so I imagine that the suppliers import quite a bit each time which would...

The last three times at 1,000 yards alot of guys have one piece c&c ground stainless machinest/ gunsmith ground custom pieces weighing 50 lbs or so....

I copied Mikes idea and it works flawless!! Id be lost without this tool. I check headspace with mine as well. Lee

I don't know what went wrong. I just want to talk to someone and get to the bottom of it so I can go shooting. Al, your a funny guy. At least you...

I'm no gunsmith, but I use the same method that Mike uses. I do it a little different in that I have my cone measuring tool as a separate part, it...

I turn my compound to where it's 29.5 degrees off of perpendicular to the lathe bed. 29.5 degrees instead of 30 degrees gives more clearance as you...

I also am running windows 8. The download and install went ok. After starting bughole I selected the first icon "Shoot..." and got the error message...

Sorry shoulda proofread first: accurateshooter.com 6br improved

Go to acurate shooter.com. There is acolumn on th left. Go to ^br improved. When you pull that up you'll find a lot on the dasher improvement...