Activity Stream

I have such a beast. The trigger is crap but useable. I chambered it in ,204 Ruger and get decent accuracy from but the magazine never worked. That...

a Lee Priming Tool years ago. Burned my left thumb quite badly. I didn't go by the directions so it was my fault, I put too many primers in the...

Doggie, on my original stock I had mounted a short piece a three inch aluminum channel. I also noticed a dramatic increase in accuracy, but it...

mineral spirits another choice ( basicly Stodard solvent - parts cleaner)

Thanks all - great suggestions! I am always looking for a way to hit the "easy button"...…..nothing replaces good old elbow grease though does it!...

I get much tactile feedback from my Lee Priming Tool. Such a simple device but it works quite well. * doggie *

I made a 3" wide nylon sled that fits into the rail under my Annie 54. Just have to machine an aluminium 'T' bar that fits the rail and attach it...

ihave used scotch brite for cleaning my case necks for over 40 yrs.

I know of 3 that are used and all competitive/winning.

When you get through cleaning yours, feel free to come by my Shop and wipe some of mine down:D ...

We were out today, just to check on some things. The club President said,......””try it out”. So Ed Bernabeo, Jim Moore, and I shot most of rhe...

Some cheap Home Depot 2” chip brushes and diesel or kerosine.

Are Tony's rails still being used in matches ?

Wrote an article for PS magazine years ago titled " On 168 I do believe ". He asked me to do testing for the article, which I did, having 3 different...

I know a lad who has 3 or 4 of his Rimfire Rifles. They are a work of art. Pete

Yes Their is a new one available on this website. Some times its difficult trying to talk to someone from the business.

I think Tony built some Rimfire Actions also, and some complete rimfire guns.. Probably best known for his stock making business.

he also sold jackets i bought many from him .

Kev, I've cleaned a few machines and have yet to find anything better than maroon Scotch Brite pads dipped in a solvent such as parts washer...

simple green and industrial paper towels rub and scrub re lube when done

me too tho mine are just bob c.

No he sold his fly rod business after his wife got sick and passes away. Jerry

I don't know if there are any easy ways to clean an older machine - I have three that I have had down to bare bones, and it just takes time and a...

Jerry is Tony still in the fly rod business?

"Feel", better termed "tactile judgement", is an acquired skill. What it, "has to do with it", is uniformly "seating" the anvil, thus, uniform...

I used the below Tub Of Towels to clean my BP Mill that had years of hard build up on it. Worked nicely for me but it does take a bit elbow grease...

One of the nicest Club ranges I have seen.

Got my second Pfizer dose and got sicker than the first time. Three days later back to my normal POST COVID level, so I still have some residual...

I still have some GTB .30 cal. 135's on the 1.080 jackets. -Al

Yes he did.