Activity Stream

That's a carry over from when Luther used to be a one day shoot. At first it was 2 pm when we'd start shooting. That allowed everyone that was...

DMort: From an old fart who drew a 4F in the draft please keep em coming. It's nice to see what I missed. bob

You have a great Smith in your own backyard! Ryan, Iowa, is home of Brian Voelker. You may want to contact him, really a nice fella to work with....

You have a PM

I just use the RCBS kinetic bullet puller. The collar type are a PITA, but less messy.

I have done this for years with Win and Fed primers. Wolf, one out of 20 was a problem. To change the load. Trying to keep all 20 brass the...

Even in my other thread I was advocating gently pushing them out, not forcible punching. If the primer pockets are tight one could compress the anvil...

It has a Sako style extractor doesn't it? If the lip of the extractor needs to go away from the bolt face a few thousandths, take a little bit off...

Bob - I'm located in Western Iowa. Jim

Tony is traveling, so wanted to get this posted up here now. It will post on the Rosebud page when Tony gets back from holidays. The Organizing...

Where are you located? Bob

Remember the Wilson hand neck sizing dies? Myself and some other people have nice neat round scares we could show you from knocking them out with a...

the ONE sure way to deactivate a primer is to FIRE it. plain and simple. yes if you deprime by PUSHING them out, they are reusable. a primer is an...

Thanks for that info Richard. Glenn

Here's the updated event schedule with fee's for each event. Friday, August 31, 2018 - 12:00 PM - PRACTICE Friday, August 31,2018 - 6:00 PM - 3...

Would you really want that primer residue crap in your good barrel? In that case, I'd suggest just loading the rounds and shooting them. What if you...

Not sure why I would do that since I no longer have the barrel that those cases with the black necks were fired in. The loaded rounds that would...

Sat will be HV and UL @100 yds and Sun will be UL and HV @ 200 yds. This is the latest information from John Dumas. John also said during the UL...

Have you made a chamber casting and verified measured neck diameter?

Just an FYI. When you fill the smaller tanks you are NOT loading them with quasi-liquid CO2 but just gas. It is possible to move liquid but...

Richard, is the unlimited 10 shot match on Saturday or Sunday? Glenn

I use a 10lb aluminum CO2 tank and a Norlin Enterprises attachment,with a regulator. Been using it for twenty years. Never noticed an issue with...

The answer would be the same. If you plan on competing at anything past casual club level you're undergunned .

Francis, always enjoy shooting with you. I'll even try to get the match going before the wind shifts on you.

Keep your calendars open for right now. I just spoke with Jim Millitello, and they are in talks with Dick Wright and the rest of the troupes about...

The safest way is to fire them --- primers are cheep I have soaked primers in oil and they can, and will, still detonate !! Gene

12 noon ??? really ?

Jackie you can also just sort your cases by rim thickness --- or trim the fat rims down by opening up the extractor groove-- sometimes Lapua dose...

Only from cooling it and condensation. The contents of the tank have no water content. You need about a 40 cubic foot tank. Around 24 inches...

Check this out: http://www.gunwarrior.com/1131/chamber-chiller-rifle-barrel-cooler-samples/