Activity Stream

I think the first thing a newer shooter needs to do is consider, is, what are your goals and intentions. Do you intend to load up the motorhome and...

Well, I have more or less the same feeling, and not using FX. Maybe, we are expecting too much from them, because we are used to rimfire...

I did try that at one time and didn't like the results. I think it was Jackie's tutorial that I used.

Parshal, Why not just do them in the lathe without using any sort of neck turning tool? Somewheres, Jackie posted a tutorial on turning necks on...

This isn't much of an installment - more like a "lack of progress" report. The barrel supplied with my rifle is a certified lead-mine. I've tried...

Just like it says a 6br will be hard to compete with a ppc short range

a friend is currently shooting a longer chamber that any of those listed, with good results. Mine now is .765", his is longer yet. Pete

No good deed goes un punished, does it? Likely I should just open the ass of the chamber up a bit, eh? Pete

See these kinds of posts fairly often and wonder why you're not building a PPC. Having said that, I would build it with a 13.5 or 14 twist and a...

The corrupted are claiming others are corrupt only to hide behind their own corruption and to look innocent to all the free wealth being gifted to...

IMHO, go 8 twist, zero freebore and start out with the lightest bullets you can get your hands on. The throat will go away faster than you think so...

to what you say. Anyone not a member has benefited by the successes of the NRA in preserving our rights as stipulated in the 2nd amendment. Shooters...

That’s all in the past. What you might need now is taller flags.

They are able to work on anything. They are GTG people.

Call Jim and Ian. I think, they work on anything....money is money. And if not, they can steer ya in the right direction. Nice guys.....

must have my numbers mixed up. i shot on the far left and needed 1 ft flags with no tails.

Ray, for the 20 or so years I have been a member, flags on the low numbered benches could easily be set at two feet or higher and still be well...

now the flag on bench one can be 2 ft high! but you need some camping spots too.

I was going to suggest Kelbly but didn’t know they only work on their own. Grizzly has Bald Eagle but I also saw that the arbor press wasn’t...

Central OH. Any thoughts on the Sinclair or Bald Eagle?

I thought I emailed them or read on their site that they only work on their stuff. Am I wrong? Not sure.

Well now, you may find that seating to the jam is most accurate.

As far as the arbor press is concerned, perhaps the K&M is the bet out there right now. Order from K&M or Midway. Where are you in Ohio?

still have 2 lv for sale and one 1000yd like new.

Call Kelbly's

Jan, I'm following your progress with great interest. Got to admit I nearly fell off the chair when I saw those pics of the barrels. As you so...

the hart is a nice press but a bit over kill for seating bullets. me thinks the $100 presses will do fine for that task (or neck sizing) add fl...

If you are in Ohio, it should not be an issue finding a gunsmith. There are a few great ones within a few hours drive. Joe

Nice press. Any reason it is better than like the Bald Eagle?

About bumping the shoulders on your cases? A lot of people use threaded type S dies, full length resizing every time. A rifle will run a lot smoother...