Activity Stream

Thanks Mike Dyslexia still occurs Correction made

Did you mean to type .264 bushing?

Neck thickness 0.011 Neck bushing 0.264 Try those #'s and adjust as desired from there. CLP

"irony"..... it ain't a river in egypt eh..... LOL

"And" corrected yourself. See, happens all the time.

At least you caught it an corrected yourself, Al. I see far more egregious errors in magazines and commercial web sites all the time. I guess they...

How many benches does this range have?

ooops, "won"........stupid voice-to-text fingers :(

I found a local guy who uses TWN Hydro films with 750 choices to the customer. I chose Brazilian Rosewood and PPG auto clear coat. Im figuring the...

The first melonited Shilen barrel we pulled out had 10741 rounds. I had to coerce my buddy that we pull it before he headed out to the Nationals at...

back when I shot high power, a local had an ar rifle with close to 9000 rounds thru it and had me swap out the bbl. it would still shoot under 2"...

Thank you

yeahh.... but ain't nobody ever measured using the term "take off just a BHH"

You did ask for "replies" :) "baseball" I agree with you BUT here is a twisted opinion..... #1- IIRC the Super Shoot was once one using a...

Gene, let's start again. I use Deltronic pins to indicate muzzle and breach. I am in the headstock with a cathead on both ends. I do warm up my...

I want to thank everyone for taking the time to share their individual means and methods it is highly appreciated on my behalf.

That's a great question Butch, and I've reversed my thoughts on it a couple of times as I sit here pondering it. My answer above, was really...

Gene, If I drill, indicate the throat, and bore to my indication at the throat, don't I have 2 points indicated?

not too many of their employees following them don't bring the whacko politics of the left coast with them.

If you compare the readings you get from running a long stylus in there, to fitting a PTG range rod. You will get two different deviations but which...

might want to check with Butches if that mixture is safe for o-rings and piston seals in an air rifle- they are completely different units than a...

good move for them - no question as to why. When I read about the fire it seemed that it was a total loss equipment wise. Fresh start in a Friendly...

Well, you have sparked my curiosity.

Best post in this entire thread.

I don’t have an indicator that will do that. I use a different method. I understand the errors inherent in my method so I won’t make claims of runout...

i will go down to the range on Wednesday to open it for practice.

I bought a little roll of the green tomater stake wire at a box store, it comes with a cutter right on the package. snip a hunk off, run it through...

I'm going to try that, I dont think T6061 is tough enough. I've come full circle with my indication, now back to ptg rods for rough in, short...

I have in the past made a double pilot indicating rod to a pre-determined length.

Which indicator do you use to find the throat to center up to bore a 2.5"-3" Magnum length case?